Inventor General Discussion

Inventor General Discussion

Reply
Member
5 Posts
0 Kudos
Registered: ‎01-08-2013
Post 1 of 1

Problem opening frame made with frame generator in ANSYS 14 workbench.

232 Views, 0 Replies
01-08-2013 06:19 PM

I am experiencing problems when opening frame made with frame generator to ansys workbench. When I try to open tubes that are notched to bent tubes made with inventor, ANSYS skippes those tubes for some reason and only opens the tubes that are not notched on bent tubes. Has someone experienced this problem and might know a solution to this?

I belive I have both ANSYS 14 fully updated as well as Inventor 2013.

On both softwares I have academic license.

 

Best regards

Tryggvi Stefánsson

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post