Inventor General Discussion

Inventor General Discussion

*Friedman, Aaron R.
Message 1 of 4 (76 Views)

Probably a simple constraint problem

76 Views, 3 Replies
12-06-2002 03:33 AM
I can't figure out how to constrain a 1" sphere to the sharp edge of a
.75 dia bore.

Aaron R. Friedman
ARF Designs
*Gwin, Hal
Message 2 of 4 (76 Views)

Re: Probably a simple constraint problem

12-06-2002 03:41 AM in reply to: *Friedman, Aaron R.
In your sketch, draw a construction line from the axis to the circumference,
dimension the construction line. Finish the sketch, add a work plane by
selecting the construction line and then an origin plane that is parallel to
the construction line. That should create a work plane at the Ø.75 tangent,
then just mate the axes (bore and sphere) and the plane to a face.

--
Hal Gwin
Mechanical Designer
Xenogen
*Friedman, Aaron R.
Message 3 of 4 (76 Views)

Re:

12-06-2002 04:09 AM in reply to: *Friedman, Aaron R.
I thought it could be done simpler that that.

thanks.

Aaron

Hal Gwin wrote:

> In your sketch, draw a construction line from the axis to the circumference,
> dimension the construction line. Finish the sketch, add a work plane by
> selecting the construction line and then an origin plane that is parallel to
> the construction line. That should create a work plane at the Ø.75 tangent,
> then just mate the axes (bore and sphere) and the plane to a face.
>
> --
> Hal Gwin
> Mechanical Designer
> Xenogen
>
>
>
*Gwin, Hal
Message 4 of 4 (76 Views)

Re:

12-06-2002 05:36 AM in reply to: *Friedman, Aaron R.
I haven't tried this, but an axes mating combined with an outside tangent
between the sphere surface and an edge (this much I have used, but is
unstable) and then an angular constraint between a sphere origin plane and
another object, plane, etc. to maintain orientation.

--
Hal Gwin
Mechanical Designer
Xenogen
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.