Inventor General Discussion

Inventor General Discussion

Reply
New Member
bbsharma11
Posts: 1
Registered: ‎07-17-2012
Message 1 of 2 (178 Views)

Preventing interference in two parts

178 Views, 1 Replies
12-04-2012 03:27 AM

Hello all , I have a rack and a sprocket, in inventor, is there any command which can prevent the interference between both all the times.

my actual problem is while driving the motion constraints, sometimes, no pin of rack is in contact with sprocket, so i want to delete the motion constraints and want to rotate the sprocket to move rack, just as actualy it happens. Is t here any way to do so?

 

i hope you can understand my concern.

 

Bharat

*Expert Elite*
JDMather
Posts: 27,513
Registered: ‎04-20-2006
Message 2 of 2 (165 Views)

Re: Preventing interference in two parts

12-04-2012 04:44 AM in reply to: bbsharma11

Attach your assembly here.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.