I am using Autodesk Inventor 2013 and for some reason I cannot access the precise input option. I can find the icon in the draw box, but it is grayed out and not clickable. Am I doing something completely wrong? Thanks for your help!
Solved! Go to Solution.
Solved! by Ryan.Martinez. See the answer in context.
You have to activate a command first... Like line
Am I doing something completely wrong?
Not to be too smart-aleck, but in 99.99% of modeling tasks with Inventor, using the Precise Input box would be completely wrong. I last used it, I believe, in my first evaluation of Inventor eleven years ago, before having any training.
What are you doing that needs the PI box?
sbixler wrote:I last used it, I believe, in my first evaluation of Inventor eleven years ago, before having any training.
I last used it in 2001 or 2002 (v5).
I don't think I have even showed my students that it exists in the past 7 or 8 years.
I'm trying to use precise input to establish points for a 3D wire path. I hope to be able to sweep a path around pulleys to mimick the wire path. My attempt is to draw circles about each point to represent the root groove of my pulley and then to draw 3D lines tangent to the circles.
So far I have not been that successful with this approach. I entered an intermediate point incorrectly and trying to "reposition" via the 3D Move / Rotate command has been difficult, other points move erractically it seems.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!