But I had no problems with constraints in V6.
Sean Dotson wrote:
256MB RAM!
OK there is probably the problem. I'm surprised you could make the parts
let
alone assemble them.
Bump this up to 768MB minimum (for assemblies of a few dozen parts)
and
1GB-2GB if you are serious about using IV.
The processor and video card you have is on the "older" end as well.
OK but
not going to be the best performer.
--
Sean Dotson, PE
http://www.sdotson.com
Check the Inventor FAQ for most common questions
www.sdotson.com/faq.html
-----------------------------------------------------------------------
"Chris Breidenbaugh" <nospam.chris@kvawelding.com> wrote in message
news:3EDCF15C.67A947FF@kvawelding.com...
> Xi Computer
> Processor is PIII 733
> 256 M Ram
> Video is 3d Labs Oxygen VX1
> NT 4.0 SP6a
> Supermicro PIIISCD Motherboard with PC133 SDRAM
>
> I have already started inquries to see if memory is still available
for
this
> computer (anything to put off buying a new one).
>
>
>
> Sean Dotson wrote:
>
> > Like this?
> >
> > I had no issues. Let's look at your system a bit closer.
> >
> > Processor, Ram, Video Card, OS etc..
> >
> > --
> > Sean Dotson, PE
> > http://www.sdotson.com
> > Check the Inventor FAQ for most common questions
> > www.sdotson.com/faq.html
> > -----------------------------------------------------------------------
> > "Chris Breidenbaugh" <nospam.chris@kvawelding.com> wrote in
message
> > news:3EDCDD39.30D3CC0E@kvawelding.com...
> > > FYI: this is crashing no matter how I try to apply constraints.
I
have
> > even
> > > gone so far as to place the Horizontal Support and start with
a new
> > vertical,
> > > but it still crashes.
> > >
> > > Sean Dotson wrote:
> > >
> > > > Chris you have to post the part (IPT) files along with the
IAM. Zip
> > them up
> > > > and try again.
> > > >
> > > > --
> > > > Sean Dotson, PE
> > > > http://www.sdotson.com
> > > > Check the Inventor FAQ for most common questions
> > > > www.sdotson.com/faq.html
> > >
> -----------------------------------------------------------------------
> > > > "Chris Breidenbaugh" <nospam.chris@kvawelding.com> wrote
in message
> > > > news:3EDCD20C.B4F971E7@kvawelding.com...
> > > > > The file in question will be posted to
> > autodesk.inventor.customer-files
> > > > > with the same subject.
> > > > >
> > >
> >
>
------------------------------------------------------------------------
> > [Image]
>