Inventor General Discussion

Reply
*Dotson, Sean
Message 1 of 2 (35 Views)

Possible IDW bug

35 Views, 1 Replies
10-31-2002 01:38 AM
Have a part file open and a IDW with views of the part. I go back to the
part and edit the tolerance of a feature via the parameters window and open
the tolerance dialogue via the equation pulldown (don't even have to change
anything just go into the tolerance window). Return to the IDW without
saving the ipart and I get the message as shown in CF.

--
Sean Dotson, PE
http://www.sdotson.com
remove all #s from email
-----------------------------------------
*McConnell, Cory
Message 2 of 2 (34 Views)

Re: Possible IDW bug

10-31-2002 02:09 AM in reply to: *Dotson, Sean
I have been getting that error quite often when I open an idw without
opening the corresponding part or assembly. When I open the part or
assembly, I update, save and close . I open the idw again and it tells me to
update again.

--
Cory McConnell
BJ pipeline Inspection
"Sean Dotson" wrote in message
news:0466FF989F23F611B25896FECEC20F37@in.WebX.maYIadrTaRb...
> Have a part file open and a IDW with views of the part. I go back to the
> part and edit the tolerance of a feature via the parameters window and
open
> the tolerance dialogue via the equation pulldown (don't even have to
change
> anything just go into the tolerance window). Return to the IDW without
> saving the ipart and I get the message as shown in CF.
>
> --
> Sean Dotson, PE
> http://www.sdotson.com
> remove all #s from email
> -----------------------------------------
>
>
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.