Inventor General Discussion

Inventor General Discussion

Reply
New Member
thinkerandplanner
Posts: 2
Registered: ‎09-24-2012
Message 1 of 5 (261 Views)
Accepted Solution

Polar equation imput?

261 Views, 4 Replies
09-24-2012 07:17 PM

I need to put in the polar equation r=e^theta. Is this even possible in autodesk? How can I do it? Should I spline through points instead?

 

Thanks

e_to_theta.png

*Expert Elite*
JDMather
Posts: 27,438
Registered: ‎04-20-2006
Message 2 of 5 (235 Views)

Re: Polar equation imput?

09-25-2012 05:04 AM in reply to: thinkerandplanner

You need Inventor 2013 for this, otherwise import Excel points.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
New Member
thinkerandplanner
Posts: 2
Registered: ‎09-24-2012
Message 3 of 5 (215 Views)

Re: Polar equation imput?

09-25-2012 01:33 PM in reply to: JDMather

I have Inventor 2013 64bit. How do I do it?

*Expert Elite*
JDMather
Posts: 27,438
Registered: ‎04-20-2006
Message 4 of 5 (211 Views)

Re: Polar equation imput?

09-25-2012 01:44 PM in reply to: thinkerandplanner

http://wikihelp.autodesk.com/Inventor/enu/2013/Help/1310-Autodesk1310/1500-Parts1500/1523-3D_sketc15...

 

http://wikihelp.autodesk.com/Inventor/enu/2013/Help/1310-Autodesk1310/1500-Parts1500/1501-2D_sketc15...

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Employee
henderh
Posts: 650
Registered: ‎06-07-2007
Message 5 of 5 (207 Views)

Re: Polar equation imput?

09-25-2012 01:46 PM in reply to: thinkerandplanner

e_to_theta.png



Hugh Henderson
Simulation QA Engineer
DLS
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.