Inventor General Discussion

Active Contributor
Posts: 45
Registered: ‎04-28-2012
Message 1 of 2 (108 Views)

pls help

108 Views, 1 Replies
07-09-2012 04:01 AM


I am facing little problem regarding hole command.

I  have to create hole on cylindrical part. and that hole is at an angle 15 degaree from vertical axis. This hole is on 200 mm pcd. ( find attachement)

I have create that hole without drawing sketch. As we do in linear option.


Pls help.


Thanks and Regards,

Datta Indalkar

With Warm Regards,
Datta Indalkar.
*Expert Elite*
Posts: 26,876
Registered: ‎04-20-2006
Message 2 of 2 (104 Views)

Re: pls help

07-09-2012 04:03 AM in reply to: indalkar.dattatray

indalkar.dattatray wrote:

I have create that hole without drawing sketch.

Why can't you use a sketch point?



Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015 64-bit
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.