Community
Hello,
I am trying to model a plastic part which is attached to each other on one side of the edge and it snaps into each other on the other side. I was able to manage the hald section of this part but not sure how to do other half.
Does anyone know how to do these plastic parts?
Thanks.
I would not use Splines in Sketch1 (especially not for straight lines).
I would Split the part (into multi-body solid) rather than extrude and cut away.
Then I would finishe one side (of course with fully constrained sketches).
Finally I would Combine - Subtract and push out the individual parts.
The CADWhisperer YouTube Channel