Inventor General Discussion

Reply
*Beissel, Josh
Message 1 of 3 (279 Views)

Placing Centerline on an arc

279 Views, 2 Replies
11-05-2002 10:33 PM
Is it Possible to place a centerline on a drawing that has an arc or radius?
(example: any dia. bar with a 90deg. bend or any deg. bend.) I want the CL
to follow the bend or arc that is placed not just straight lines horizontal
or vertical. I can get centerlines on my drawing as long as the lines I'm
working with are parallel or holes. I hope this is enough information.
Thanks Josh
Distinguished Contributor
jiml
Posts: 387
Registered: ‎12-10-2003
Message 2 of 3 (279 Views)

Re: Placing Centerline on an arc

11-06-2002 12:07 AM in reply to: *Beissel, Josh
If I understand correct. You have to do use a center line bisector pick the two arc lines
*Beissel, Josh
Message 3 of 3 (279 Views)

Re:

11-06-2002 12:24 AM in reply to: *Beissel, Josh
Yes that worked.  I used all of the tools
except that one when I was trying.  thanks


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
If
I understand correct. You have to do use a center line bisector pick the two
arc lines
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.