Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

pipe length

1 REPLY 1
Reply
Message 1 of 2
tsangsiuyan
147 Views, 1 Reply

pipe length

when i checked the iproperty of the file of pipe segment, i found that there are two terms inside "custom", which are PL and L. Their units are both"mm" and their value are the sane. I guess that they are pipe length.
But, i don't know the difference between them , "L" and "PL".
please tell me
thx
1 REPLY 1
Message 2 of 2
Anonymous
in reply to: tsangsiuyan

I think with AIP r7 it was L and then in AIP r8 they changed it to be more specific to piping. -Kevin "tsangsiuyan" wrote in message news:18044788.1083564036344.JavaMail.jive@jiveforum2.autodesk.com... > when i checked the iproperty of the file of pipe segment, i found that there are two terms inside "custom", which are PL and L. Their units are both"mm" and their value are the sane. I guess that they are pipe length. > But, i don't know the difference between them , "L" and "PL". > please tell me > thx

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report