Inventor General Discussion

Inventor General Discussion

Reply
Contributor
kwikscopeguy
Posts: 13
Registered: ‎01-09-2013
Message 1 of 3 (129 Views)

Photos won't show up in presentation

129 Views, 2 Replies
01-11-2013 08:23 AM

I have put photos in the part and the assembly but they wont show up in the presentation. help?

i5 3570k@4.4ghz gtx 670, 8gb ddr3 1600mhz
*Expert Elite*
blair
Posts: 4,192
Registered: ‎11-13-2006
Message 2 of 3 (125 Views)

Re: Photos won't show up in presentation

01-11-2013 08:28 AM in reply to: kwikscopeguy

You would need to use the Decal command to apply the pictures to the parts. Once the Presentation is complete and placed in a Drawing, the drawing would need to have the
Color" option for the view enabled.

 

Possible post a screen show of what you are doing or trying to do/accomplish.

Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

IV2015 SP1 PDSU / Sim Mech 2015 r1 /
Win7-64
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 340.52
SpacePilot Pro 3.17.7, 6.17., 4.11
Delta Tau Chi ΔΤΧ
Active Contributor
billyb
Posts: 53
Registered: ‎04-13-2005
Message 3 of 3 (112 Views)

Re: Photos won't show up in presentation

01-11-2013 10:02 AM in reply to: kwikscopeguy

When setting up the image parameters, or editing them, you can tell the image to Wrap around faces and to span/cross face boundaries. The results can look like this:

Decal_2012.png

Bill Bogan
- Providing freelance visualization
- Inventor: Expert
- Revit: Novice and growing...
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.