Its in the options section when you save the PDF, see picture.
Thanks for quick reply, but this is what I have done.
I wan't it thinner? Is there an setting to control that?
If you save the IDW as DWG an then print to PDF the lines are thinner, so I think it is an Inventor setting
I am not too sure, I only use dwg's, maybe someone else has some expertise in this area. That check box is what I use to control line weights on pdfs.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!