Inventor General Discussion

Inventor General Discussion

Reply
*Expert Elite*
Cadmanto
Posts: 3,356
Registered: ‎12-07-2011
Message 1 of 4 (207 Views)
Accepted Solution

Parts List Wrapping Direction

207 Views, 3 Replies
12-06-2012 11:39 AM

When a parts list in an Inventor drawing is wrapped it always takes the bottom portion and kicks it to the left.

Is there a way to kick it to the right?  So when you are looking at the BOM it reads such that item 1 is in the first group and not the second.

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

Hi Cadmanto,

 

You can right-click on the parts list and choose Edit Parts List, then click the Table Layout button, then set the wrap direction. I don't recall a way to set this up in the Parts List style, but there might be one.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

*Expert Elite*
Curtis_Waguespack
Posts: 3,002
Registered: ‎03-08-2006
Message 2 of 4 (192 Views)

Re: Parts List Wrapping Direction

12-06-2012 12:14 PM in reply to: Cadmanto

Hi Cadmanto,

 

You can right-click on the parts list and choose Edit Parts List, then click the Table Layout button, then set the wrap direction. I don't recall a way to set this up in the Parts List style, but there might be one.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





*Expert Elite*
Cadmanto
Posts: 3,356
Registered: ‎12-07-2011
Message 3 of 4 (184 Views)

Re: Parts List Wrapping Direction

12-06-2012 12:44 PM in reply to: Curtis_Waguespack

Thanks Curtis.

That was almost too easy!!!  :smileyhappy:

Best Regards,
Scott McFadden
Inventor Professional 2014
(Colossians 3:23-25)

Valued Mentor
BLHDrafting
Posts: 350
Registered: ‎10-12-2012
Message 4 of 4 (162 Views)

Re: Parts List Wrapping Direction

12-06-2012 05:20 PM in reply to: Cadmanto

There is also a radio button set when placing the parts list. See graphic.

 

Capture.JPG

Brendan Henderson

Web www.blh.com.au
Twitter @BLHDrafting

Windows 7 x64 -64 GB Ram, Intel Xeon E5-1620 @ 3.6 GHz
ATI FirePro V7800 2 GB, 180 GB SSD & 1 TB HDD, Inv R2013 PDS Premium SP2 Update 3 (Build 200), Vault 2013 Workgroup Update 2 (Build 17.2.9.0)
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.