Inventor General Discussion

Inventor General Discussion

Reply
Contributor
ronalddamey
Posts: 17
Registered: ‎09-13-2006
Message 1 of 3 (292 Views)

PARTS LIST - WRAP TABLE AT ROW SPACE

292 Views, 2 Replies
12-11-2009 08:57 AM
It's probably not possible, but I was trying to find a way in a Parts List when using 'WRAP TABLE AT ROW" to have a space between the right and left parts list. Do anyone know if this is possible.
Distinguished Mentor
pauldoubet
Posts: 703
Registered: ‎10-11-2006
Message 2 of 3 (292 Views)

Re: PARTS LIST - WRAP TABLE AT ROW SPACE

12-12-2009 09:35 AM in reply to: ronalddamey
There is a work around to this but it is a pain. You can copy the parts list after you wrap the parts list where you want. Then paste the copy off to the side. Now edit the first parts list and hide all the rows below the line where it is wrapped. Now edit the copy you created and hide all the lines above the line where it is wrapped. Now move the copy into the correct position and allow the gap you want between the two parts lists.

Hope this helps, Paul
Valued Contributor
andrewwhiteinc
Posts: 59
Registered: ‎02-02-2011
Message 3 of 3 (155 Views)

Re: PARTS LIST - WRAP TABLE AT ROW SPACE

09-26-2012 12:29 PM in reply to: pauldoubet

Anyone know if this is possible now? I did the work around but this would be cleaner.

P. Andrew White,EIT
Engineer-in-Training, Industrial Automation
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.