Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
Infoseeker
Posts: 195
Registered: ‎03-15-2012
Message 1 of 2 (71 Views)

Parts List - "each" vs ".in"

71 Views, 1 Replies
04-05-2012 12:25 PM

What exacly determines that a part is listed in Parts Lists as EACH or for Length f.e.?

*Expert Elite*
Curtis_Waguespack
Posts: 2,963
Registered: ‎03-08-2006
Message 2 of 2 (65 Views)

Re: Parts List - "each" vs ".in"

04-05-2012 12:59 PM in reply to: Infoseeker

Hi Infoseeker, 

 

You can set this in the part by going to the Tools tab > Doucment Settings > Bill of Materials tab,  and setting the Base Quantity setting.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com




  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.