Inventor General Discussion

Reply
*Sam
Message 1 of 2 (57 Views)

Part vs sheetmetal

57 Views, 1 Replies
11-16-2002 11:52 PM
Is there anyway to convert a sheet metal part into a regular part?

Is there any difference except fot the menu it defaults to?
*Keller, Kent
Message 2 of 2 (57 Views)

Re: Part vs sheetmetal

11-17-2002 12:17 AM in reply to: *Sam
The biggest difference is the menus, and SM adds a few
parameters....Thickness act. To switch it just to etc. Applications
dropdown, and change it from Sheet Metal to Modeling.

--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program

http://www.MyMcad.com/KWiK/Mcad.htm

"Sam" wrote in message
news:F104AFC59EDDC932B7A8483105E8DF92@in.WebX.maYIadrTaRb...
> Is there anyway to convert a sheet metal part into a regular part?
>
> Is there any difference except fot the menu it defaults to?
>
>
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.