Inventor General Discussion

Reply
*Sam
Message 1 of 2 (58 Views)

Part vs sheetmetal

58 Views, 1 Replies
11-16-2002 11:52 PM
Is there anyway to convert a sheet metal part into a regular part?

Is there any difference except fot the menu it defaults to?
*Keller, Kent
Message 2 of 2 (58 Views)

Re: Part vs sheetmetal

11-17-2002 12:17 AM in reply to: *Sam
The biggest difference is the menus, and SM adds a few
parameters....Thickness act. To switch it just to etc. Applications
dropdown, and change it from Sheet Metal to Modeling.

--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program

http://www.MyMcad.com/KWiK/Mcad.htm

"Sam" wrote in message
news:F104AFC59EDDC932B7A8483105E8DF92@in.WebX.maYIadrTaRb...
> Is there anyway to convert a sheet metal part into a regular part?
>
> Is there any difference except fot the menu it defaults to?
>
>
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.