Okay, that did it. Thanks!
Kent Keller wrote:
> Have you tried preselecting the face before making the flat?
>
> --
> Kent
> Member of the Autodesk Discussion Forum Moderator Program
>
>
> "Jason M" wrote in message
> news:BA10F0D383A46FEC869FF05711ADC8A4@in.WebX.maYIadrTaRb...
>
>>Hello!
>>
>>I have a part that I made by drawing the profile and extruding the
>>profile out. I would like to make this into a sheetmetal part so that I
>>can get a flat layout, and show where the bend lines are, but when I do
>>that, it uses the profile as the face, so instead of having a 10 inch
>>wide piece of sheet aluminum that's bent, I end up with a 0.100 inch
>>thick profile.
>>
>>Can anyone help? I'll put it in CF.
>>-Jason
>>
>
>
>