Inventor General Discussion

Inventor General Discussion

Reply
Contributor
mark0ms
Posts: 23
Registered: ‎09-30-2003
Message 1 of 3 (41 Views)

PART TIME KEY IN AN IPART

41 Views, 2 Replies
12-05-2002 02:40 AM
How do I set up a parameter in an iPart table so that it is a key for some parts, but not others created by the factory?
*Keller, Kent
Message 2 of 3 (41 Views)

Re: PART TIME KEY IN AN IPART

12-05-2002 03:14 AM in reply to: mark0ms
Don't think you can. you can however make it so it only has one value in that key when
needed.

--
Kent
Member of the Autodesk Discussion Forum Moderator Program


"mark0ms" wrote in message news:f129f09.-1@WebX.maYIadrTaRb...
> How do I set up a parameter in an iPart table so that it is a key for some parts, but
not others created by the factory?
*Dotson, Sean
Message 3 of 3 (41 Views)

Re:

12-05-2002 09:28 PM in reply to: mark0ms
yep..

--
Sean Dotson, PE
http://www.sdotson.com
Check the Inventor FAQ for most common questions
http://www.sdotson.com/faq.html
-----------------------------------------
"Kent Keller" wrote in message
news:ED22F0E2405295BDE62378AFFEBD0F00@in.WebX.maYIadrTaRb...
> Don't think you can. you can however make it so it only has one value in
that key when
> needed.
>
> --
> Kent
> Member of the Autodesk Discussion Forum Moderator Program
>
>
> "mark0ms" wrote in message
news:f129f09.-1@WebX.maYIadrTaRb...
> > How do I set up a parameter in an iPart table so that it is a key for
some parts, but
> not others created by the factory?
>
>
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.