yep..
--
Sean Dotson, PE
http://www.sdotson.com
Check the Inventor FAQ for most common questions
http://www.sdotson.com/faq.html
-----------------------------------------
"Kent Keller" wrote in message
news:ED22F0E2405295BDE62378AFFEBD0F00@in.WebX.maYIadrTaRb...
> Don't think you can. you can however make it so it only has one value in
that key when
> needed.
>
> --
> Kent
> Member of the Autodesk Discussion Forum Moderator Program
>
>
> "mark0ms" wrote in message
news:f129f09.-1@WebX.maYIadrTaRb...
> > How do I set up a parameter in an iPart table so that it is a key for
some parts, but
> not others created by the factory?
>
>