Inventor General Discussion

Inventor General Discussion

Reply
Contributor
ericjed13
Posts: 20
Registered: ‎10-09-2012
Message 1 of 1 (190 Views)

Part Fill Analysis and Part Shrinkage Update

190 Views, 0 Replies
01-30-2013 06:11 PM

I'm using Autodesk Inventor Tooling 2013 and uses the functions Part Fill Analysis and Part Shrinkage to check on the quality of my part.

 

The problem is that once I perform Part Shrinkage, a thunder symbol for Part Fill Analysis results appears which means I should update it. But once I do Part Fill Analysis again, it's then my Part Shrinkage results that need to be updated.

 

The loop continues and I dont know where to settle.

 

Is there a way such that my resullts for Part Fill Analysis and Part Shrinkage come simulataneous and that either of them doesnt need to be updated?

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.