Inventor General Discussion

Inventor General Discussion

Reply
Active Member
2shaen
Posts: 8
Registered: ‎10-31-2012
Message 1 of 3 (155 Views)

Part configuratoin

155 Views, 2 Replies
11-19-2012 10:45 PM

I want to ask if in Autodesk Inventor 2013, can we create a part with a different configuration??


example:

I made a cube the size of 10mm x 10mm x 10mm, after which it would be revised measures 15mm x 15mm x 15mm. The second revision to change the size of a 12mm x 12mm x 12mm.
Can all the revision is done in one file?
And if I want to revise again be 10mm x 10mm x 10mm, can?

 

Have I been that provides revision always create a new file and the file number so much that hard to figure out which revision. Sorry, because I am still learning Autodesk Inventor 2013.

 

thanks before,

*Pro
sbixler
Posts: 1,881
Registered: ‎09-15-2003
Message 2 of 3 (136 Views)

Re: Part configuratoin

11-20-2012 03:41 AM in reply to: 2shaen

iParts allow you to create multiple versions of the same part, defined by values in a table.  Each of these, when placed in an assembly, actually creates a separate file for that size.  So, in your example, the iPart could define many different combinations of length, width and height, but only the ones that you have actually chosen to place in assemblies would be created as separate files.

 

Is this what you are asking?  If I didn't understand properly, post again.

*Expert Elite*
Cadmanto
Posts: 3,239
Registered: ‎12-07-2011
Message 3 of 3 (124 Views)

Re: Part configuratoin

11-20-2012 07:48 AM in reply to: 2shaen

Like Sam said, creating iparts is the way to go.

But understand once you have created them you need to generate them in order to get them

to show effectively in your assemblies.

Best Regards,
Scott McFadden
Inventor Professional 2013
(Colossians 3:23-25)

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.