Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎09-12-2012
Message 1 of 2 (165 Views)

Part Configurations

165 Views, 1 Replies
09-12-2012 12:35 PM

Say I have a small rectangular part that appears once in a model.


Can I design the original part so it's fabricated in a strip of 10 parts - then place a "configuration" of the part in a model that only shows 1 of the 10 parts?


SW is my first tool - but I'm (happily) using Inventor at the moment. Thanks!

*Expert Elite*
Posts: 3,247
Registered: ‎12-07-2011
Message 2 of 2 (157 Views)

Re: Part Configurations

09-12-2012 12:42 PM in reply to: jpoulette

Welcome to the forum.

In Inventor they call them factory and iparts.  Take a look at the attached link.

But yes it can be done.

Best Regards,
Scott McFadden
Inventor Professional 2013
(Colossians 3:23-25)

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.