Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
kdlklm
Posts: 29
Registered: ‎05-09-2006
Message 1 of 3 (315 Views)
Accepted Solution

pack and go problem

315 Views, 2 Replies
07-22-2011 12:46 PM

after doing a pack and go, to transfer my project from my old machine to my new machine. it continuously gives me this error message when I open up the file. I have attached a screenshot.

 

 

Hi

I think your Content Center is not properly maped

try this

1-pack and go option  :skip library, checked .click ok let the process run and close

2-in your old machine go inventor application option, Content Center tab, find the location of the library

3-copy the folder and transfert it to the new machine in the folder indicated in application option

other workflow

 you can grab the same folder and paste it in library folder who is set  up in the project option

good luck

Valued Mentor
yannick3
Posts: 468
Registered: ‎11-19-2006
Message 2 of 3 (296 Views)

Re : pack and go problem

07-22-2011 03:49 PM in reply to: kdlklm

Hi

I think your Content Center is not properly maped

try this

1-pack and go option  :skip library, checked .click ok let the process run and close

2-in your old machine go inventor application option, Content Center tab, find the location of the library

3-copy the folder and transfert it to the new machine in the folder indicated in application option

other workflow

 you can grab the same folder and paste it in library folder who is set  up in the project option

good luck

Yannick Verreault
INV PRO 2015
MS Office 2007
Win 7 pro, core i7 950, asus P6T WS
nvidia Gforce GTX 295
WD caviar black 500Go
WD caviar black 1To

New Member
josemireigada
Posts: 1
Registered: ‎10-09-2012
Message 3 of 3 (122 Views)

Re: pack and go problem

10-09-2012 03:03 AM in reply to: kdlklm

Hello!

 

Another problem with the Pack&Go


When I Pack and Go some models with parts developed with Frame Generator and I want to make changes with Edit in Frame Generator I cannot find the shapes in the Content Center.

Thanks in advance.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.