Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
spawn510
Posts: 34
Registered: ‎02-23-2010
Message 1 of 2 (182 Views)

Order of Parts in presentationm mode Bill of Materials

182 Views, 1 Replies
10-07-2010 05:38 AM

Good morning,

 

I have a small ordering problem when making a presenation (.ipn) file. The files in the IPN tree appear as you put them in inventor when making the assembly, not as you sorted them. This makes it very hard to explode a 400+ component assembly if they are not in order. It seems that they are also linked to the "model Data" tab in the bill of materials. Is there a way to re-order these components?

 

I can sort them in the BOM structured and Parts only tabs only. What I want to do is alphabetically sort them in the Model Data tab as well. Hopefully, I will be able to properly select my components afterwards in the presentation file.

 

I am usnig Inventor 2010.

 

Thank you.

Active Contributor
spawn510
Posts: 34
Registered: ‎02-23-2010
Message 2 of 2 (176 Views)

Re: Order of Parts in presentationm mode Bill of Materials

10-07-2010 06:16 AM in reply to: spawn510

A clarification on my question:

 

I was able to reorder the components in the Model Data in the Bill of Materials. Then, when I create a new presentation file, the new order is displayed, which I am very happy with.

 

However, I have a large assembly that I created before I change the order, a few months back, and the new order is not displayed. So I added components to my assembly, and they appear at the bottom of the tree on the ipn file, even though they are sorted both in the bill of material and the model tree of the .iam file.

 

Any help on this would be greatly appreciated. I would rather not have to do it all by selecting my components one at a time.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!