Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
leandrav
Posts: 43
Registered: ‎10-10-2012
Message 1 of 2 (258 Views)

Opening Revit.rfa files in Inventor

258 Views, 1 Replies
03-14-2014 12:59 AM

Hi,

 

I have a disk of Revit.rfa files that i have been told i can open in inventor.

When i try to open the file Inventor tells me that I can't.

 

Is there a special trick to doing this or is it just not possible at all?

 

Thanks,

Leandra

*Expert Elite*
Curtis_Waguespack
Posts: 2,955
Registered: ‎03-08-2006
Message 2 of 2 (227 Views)

Re: Opening Revit.rfa files in Inventor

03-14-2014 09:22 AM in reply to: leandrav

Hi leandrav,

 

Assuming you are using Inventor 2014, this link might help:

http://www.cadlinecommunity.co.uk/Blogs/Blog.aspx?ScoId=723b16e3-992b-42c1-8bb7-0b812d2bd183

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.