Inventor General Discussion

Reply
*ncabilan
Message 1 of 2 (33 Views)

Opening files

33 Views, 1 Replies
12-17-2002 02:10 AM
Is there a way in R6 where we could default Inventor to go to the workspace
folder when opening files instead of going to some other folders in the
search paths?

TIA
ncabilan
Distinguished Contributor
rllthomas
Posts: 2,068
Registered: ‎12-10-2003
Message 2 of 2 (33 Views)

Re: Opening files

12-17-2002 02:30 AM in reply to: *ncabilan
As near as I can tell the current behavior is this, if you have enough paths listed Inventor scrolls down to bottom of the list in the dialog box. The top visible path is then where Inventor defaults to. We messed around and nested things such that the list was shorter and the workspace was always visible then it works as you requested. Not a good solution but the only one I have.

Rich Thomas
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.