Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
jstorella
Posts: 31
Registered: ‎07-08-2011
Message 1 of 3 (133 Views)

Open (Check Out All)

133 Views, 2 Replies
07-03-2012 11:29 AM

The Open (Check Out All) option is grayed-out when opening an Inventor file from Vault. How do I activate this?

Jerry

Product Support
r.smith1
Posts: 216
Registered: ‎01-19-2011
Message 2 of 3 (86 Views)

Re: Open (Check Out All)

07-19-2012 02:27 PM in reply to: jstorella

Hi Jerry,

Are you saying that when you use the open from Vault command in Inventor, the Check Out All option is grayed out?:



Ron Smith
Front Line Technical Support Specialist - Data Management
Autodesk, Inc.

http://help.autodesk.com/view/VAULT/2014/ENU/
http://crackingthevault.typepad.com/
http://underthehood-autodesk.typepad.com/
Active Contributor
jstorella
Posts: 31
Registered: ‎07-08-2011
Message 3 of 3 (71 Views)

Re: Open (Check Out All)

07-20-2012 05:14 AM in reply to: r.smith1
Thanks for the reply and sorry I could have worded my issue better. To answer your question, no I did not mean to imply that. The issue is, when opening an .idw, .ipn, .iam from Vault using Inventor, I have four options - Open, Open (Check Out), Open (Check Out All) and Open (Read Only). I normally use Open (Check Out All). For some reason that option is "Grayed Out" and not active. I found a work around that takes a few extra steps, but wanted to know why this happened and what I could do to correct it. Jerry Storella Engineering Department Dynamic Aviation 540-828-6070, ext. 3789
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.