Inventor General Discussion

Inventor General Discussion

Reply
Active Contributor
Kris_Inv2013
Posts: 39
Registered: ‎07-19-2012
Message 1 of 2 (286 Views)

open and update drawing from assembly via iLogic

286 Views, 1 Replies
11-12-2012 07:39 AM

Hi All,

 

The right click context menu on the top level assembly (on the model tree in Inventor) has the option of 'Open Drawing'.

Is there a way to do that via iLogic? Unfortunately I can't figure it out if there is. I would like to open and update the relevant drawing.

 

Also have tried it the other way around, that is to run my rues in the assembly from the drawing since the drawing is the parent. But I am not sure how to reference the assembly.

 

 

Any comment would be much apprecated.

 

thanks,

 

Kris

 

Active Contributor
Kris_Inv2013
Posts: 39
Registered: ‎07-19-2012
Message 2 of 2 (248 Views)

Re: open and update drawing from assembly via iLogic

11-19-2012 12:48 AM in reply to: Kris_Inv2013

Hi,

 

Am I in the wrong discussion group? Is there group administrator/moderator/tech supp engineer to look at these questions?

 

Many thanks,

Kris

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.