Inventor General Discussion

Inventor General Discussion

Reply
Distinguished Contributor
acad-caveman
Posts: 165
Registered: ‎08-21-2009
Message 1 of 3 (211 Views)
Accepted Solution

One part ( model ) - multiple part numbers - How-to

211 Views, 2 Replies
08-11-2012 01:54 PM

Gentlemen,sorry for a possibly dumb question.

What is the best way to handle a single model but have multiple part ( drawing ) numbers assigned to it?

I have a customer who has the silly tendency to assign new part numbers to each iteration of an assembly.

The assemblies do vary and have unique part numbers as a whole, but the components used in them are typically interchangeable.

What's more, the assembly part number never correlates to the individual components used in them.

What's even more, they sometimes order only a single component and they refer to it only by it's own part number, so I cannot just call up the assembly and figure out what part they need.

 

What I'd like to do is create one model of the component, and then save it with multiple part numbers. I don't mind having multiple files, each representing a part number, but if there is any change, I'd like it to progate throughout all the identical files.

 

IOW, I have Part#, Part#2 and part#3. They are identical. How can I draw Part#1 and save it as 2 other linked drawings so any edits to the original will change the others as well.

 

Thank You

 

 

iParts would be the way to go. You will have to create a bunch of children in a table where you can assign a different number to each one.

Regards,

Igor.

Distinguished Mentor
IgorMir
Posts: 535
Registered: ‎08-02-2003
Message 2 of 3 (203 Views)

Re: One part ( model ) - multiple part numbers - How-to

08-11-2012 06:00 PM in reply to: acad-caveman

iParts would be the way to go. You will have to create a bunch of children in a table where you can assign a different number to each one.

Regards,

Igor.

Web: www.meqc.com.au
Distinguished Contributor
acad-caveman
Posts: 165
Registered: ‎08-21-2009
Message 3 of 3 (152 Views)

Re: One part ( model ) - multiple part numbers - How-to

08-13-2012 04:40 PM in reply to: acad-caveman

Thanks Igor.

Being primarily a jobshop and use Inventor for re-creating solid models from paper blueprints, to date I did not have to dig deeper into IV's design related capabilities.

This would be a perfect time to do so for this purpose.

 

Thank You

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.