Inventor General Discussion

Inventor General Discussion

Reply
Valued Contributor
aaron
Posts: 50
Registered: ‎08-26-2010
Message 1 of 5 (515 Views)
Accepted Solution

Offset in Sketch

515 Views, 4 Replies
02-17-2014 11:35 AM

Im sure this is a simple solution, but I cant figure it out. On my computer at work, if I use the offset feature (2D sketch) I get a different result than I do on my home computer. For example. If I draw a rectangle and then offset that drawing and dimension it .75, all it takes is that one dimension to constrain the entire offset. On my work computer if I offset that same rectangle, I have to go dimension each line. I can find a way to change the "rules" of that feature. Thanks

Right click before you place it and "Constrain Offset"

*Expert Elite*
dan_inv09
Posts: 2,360
Registered: ‎12-12-2006
Message 2 of 5 (511 Views)

Re: Offset in Sketch

02-17-2014 11:44 AM in reply to: aaron

Right click before you place it and "Constrain Offset"

Valued Contributor
aaron
Posts: 50
Registered: ‎08-26-2010
Message 3 of 5 (506 Views)

Re: Offset in Sketch

02-17-2014 11:47 AM in reply to: dan_inv09

Thanks. Kind of a self taught guy here, outside of learning the complex stuff from the masters on here.

*Expert Elite*
dan_inv09
Posts: 2,360
Registered: ‎12-12-2006
Message 4 of 5 (495 Views)

Re: Offset in Sketch

02-17-2014 11:59 AM in reply to: aaron

Actually anytime between when you click the offset icon and when you place it you can change that.

 

A little tip for people learning Inventor - try right clicking, lots of good stuff is hidden there. If you think, "It would make sense that if I'm doing this I could ..." it's probably there if you right click.

Valued Contributor
aaron
Posts: 50
Registered: ‎08-26-2010
Message 5 of 5 (492 Views)

Re: Offset in Sketch

02-17-2014 12:05 PM in reply to: dan_inv09
good point!

Sincerely,
Aaron Vogler

Vogler Metalwork & Design
ph-812.615.0042
fx-812.615.0171
aaron@voglermetaldesign.com
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.