Inventor General Discussion

Inventor General Discussion

Reply
Member
crepps581
Posts: 5
Registered: ‎10-05-2011
Message 1 of 5 (724 Views)

notch beams perpendicular to each other

724 Views, 4 Replies
10-25-2011 12:19 PM

I have a situation where need to frame a W14x30 into a W14x61.  When I perform the Notch command, the W14x30 is only partially notched. The W14x61 is taller by .05 in. I tried to notch the W14x30 by ending it at the flange edge of the W14x61.  I also tried to notch by ending the W14x30 on the other side of the W14x61, both attempts yielding no results.  Any guidance to resolve this is greatly appreciated.

*Expert Elite*
JDMather
Posts: 28,228
Registered: ‎04-20-2006
Message 2 of 5 (719 Views)

Re: notch beams perpendicular to each other

10-25-2011 12:22 PM in reply to: crepps581

I think you will need to first increase the length so that they intersect.
Can you attach the assembly here?

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Member
crepps581
Posts: 5
Registered: ‎10-05-2011
Message 3 of 5 (718 Views)

Re: notch beams perpendicular to each other

10-25-2011 12:23 PM in reply to: crepps581

Found a solution to my own question:  Trim/Extend W14x30 to the face of W14x61, then Notch.

*Expert Elite*
cbenner
Posts: 3,421
Registered: ‎04-06-2010
Message 4 of 5 (712 Views)

Re: notch beams perpendicular to each other

10-25-2011 12:25 PM in reply to: crepps581

I might add, from experience, anytime you are doing a notch function that also requires a trim... do the trim first, so that the G_L cut length will be correct.  We've found (at least in 2011) that if you notch first and then trim, the length value does not update.

ChrisB

ADSK_Expert_Elite_Icon_S_Color_Blk.png

Please use Mark Solutions!.Accept as Solution &Give Kudos!Kudos to further enhance the value of these forums. Thank you! :smileyhappy:

http://cadtipstricks.wordpress.com//


   

Member
crepps581
Posts: 5
Registered: ‎10-05-2011
Message 5 of 5 (710 Views)

Re: notch beams perpendicular to each other

10-25-2011 12:25 PM in reply to: crepps581

*face of the W14x61 web

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.