I have a situation where need to frame a W14x30 into a W14x61. When I perform the Notch command, the W14x30 is only partially notched. The W14x61 is taller by .05 in. I tried to notch the W14x30 by ending it at the flange edge of the W14x61. I also tried to notch by ending the W14x30 on the other side of the W14x61, both attempts yielding no results. Any guidance to resolve this is greatly appreciated.
I think you will need to first increase the length so that they intersect.
Can you attach the assembly here?
I might add, from experience, anytime you are doing a notch function that also requires a trim... do the trim first, so that the G_L cut length will be correct. We've found (at least in 2011) that if you notch first and then trim, the length value does not update.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.