Inventor General Discussion

Inventor General Discussion

Reply
New Member
karlbauer2
Posts: 1
Registered: ‎12-05-2002
Message 1 of 3 (67 Views)

Normparts in Draftmode should not be cut through ???

67 Views, 2 Replies
12-05-2002 06:25 PM
How can I change the representation of a standard part (screw)in a cutted view? Refering to the DIN norm a standard part should not be cutted.
Distinguished Contributor
jiml
Posts: 387
Registered: ‎12-10-2003
Message 2 of 3 (67 Views)

Re: Normparts in Draftmode should not be cut through ???

12-05-2002 11:31 PM in reply to: karlbauer2
Do you mean a section view? If so before the making of the section view show contents in the view you want to cut go to the part in the list right click on the part uncheck section now when you cut the part will stay whole
*Holzwarth, W.
Message 3 of 3 (67 Views)

Re:

12-06-2002 12:19 AM in reply to: karlbauer2
Hmm,
I could imagine, that these standars parts, who are normally not cut, are
unchecked from cutting by DEFAULT. I'm thinking of screws, nuts, washers,
but not of ball bearings. I think this could be divided very nicely

Walter

"jiml" schrieb im Newsbeitrag
news:f12a24a.0@WebX.maYIadrTaRb...
Do you mean a section view? If so before the making of the section view show
contents in the view you want to cut go to the part in the list right click
on the part uncheck section now when you cut the part will stay whole

"karlbauer2" asked:
How can I change the representation of a standard part (screw)in a cutted
view? Refering to the DIN norm a standard part should not be cutted.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.