Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Normparts in Draftmode should not be cut through ???

2 REPLIES 2
Reply
Message 1 of 3
karlbauer2
122 Views, 2 Replies

Normparts in Draftmode should not be cut through ???

How can I change the representation of a standard part (screw)in a cutted view? Refering to the DIN norm a standard part should not be cutted.
2 REPLIES 2
Message 2 of 3
jiml
in reply to: karlbauer2

Do you mean a section view? If so before the making of the section view show contents in the view you want to cut go to the part in the list right click on the part uncheck section now when you cut the part will stay whole
Message 3 of 3
Anonymous
in reply to: karlbauer2

Hmm,
I could imagine, that these standars parts, who are normally not cut, are
unchecked from cutting by DEFAULT. I'm thinking of screws, nuts, washers,
but not of ball bearings. I think this could be divided very nicely

Walter

"jiml" schrieb im Newsbeitrag
news:f12a24a.0@WebX.maYIadrTaRb...
Do you mean a section view? If so before the making of the section view show
contents in the view you want to cut go to the part in the list right click
on the part uncheck section now when you cut the part will stay whole

"karlbauer2" asked:
How can I change the representation of a standard part (screw)in a cutted
view? Refering to the DIN norm a standard part should not be cutted.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report