Inventor General Discussion

Active Contributor
Posts: 31
Registered: ‎07-08-2011
Message 1 of 1 (56 Views)

Nonexistent Parts

56 Views, 0 Replies
05-21-2012 10:54 AM

I had a problem last week. You can look up the posting with the same title above for a description of it. A work around was given and it fixed the problem. I'm writing this time to say I believe it is connected to Vaults Copy Design tool because it happen again today after using it.


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.