Inventor General Discussion

Reply
Valued Contributor
eric.mathews
Posts: 86
Registered: ‎04-19-2006
Message 1 of 2 (635 Views)
Accepted Solution

No Vault Tool bar 2013.

635 Views, 1 Replies
10-19-2012 06:47 AM

I recently installed Vault pro 2013. I was running Inventor 2012 at the time.. My vault add-in stopped loading. I installed Inventor 2013 and the vault add-in still won't load. I've gone to the Add-in manager 2013 and set it to loaded. I hit the "OK" button and nothing. Open the manager up again and it says "unloaded". Something is going on that is not allowing my vault add-in to load. This is very frustrating. Any suggestions?

 

Have you tried changing the Vault Client from Programs and Features?

  1. Right click on the Vault Client and select Change.
  2. Now select Add / Remove Features.
  3. Un-check the Add-in for Inventor.
  4. Update.
  5. Now go back and this time check the option to add the Add-in.
  6. Update.

Hopefully this should work OK.

Jon.

Product Support
jon.dean
Posts: 193
Registered: ‎06-02-2010
Message 2 of 2 (610 Views)

Re: No Vault Tool bar 2013.

10-22-2012 06:20 AM in reply to: eric.mathews

Have you tried changing the Vault Client from Programs and Features?

  1. Right click on the Vault Client and select Change.
  2. Now select Add / Remove Features.
  3. Un-check the Add-in for Inventor.
  4. Update.
  5. Now go back and this time check the option to add the Add-in.
  6. Update.

Hopefully this should work OK.

Jon.



Jon Dean

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.