No-profile when mirroring in a sketch

[Anonymous]

I don't understand this but when I do a mirror in a sketch and try to extrude a cut into a part Inventor views the mirrored portion as an unclosed profile. Is there a way to force the mirrored portion to become a closed profile without removing the mirror constraint? And yes the part is semetric in all axis.

[Anonymous]

This was an issue in 5.3. Are you on IV6 SP2?

--
Dennis Jeffrey
CAD Associates - Fort Wayne
Autodesk University Instructor
Autodesk ASC
(260-432-9695 x 221

[Anonymous]

Is the sketch marked adaptive?

Is the sketch shared?

If the mirror was done post-sharing, the extrusion command will only "see"
the profile if the original feature (pre-share) is marked un-adaptive.

QBZ


"ohunome" wrote in message
news:f13f796.-1@WebX.maYIadrTaRb...
> I don't understand this but when I do a mirror in a sketch and try to
extrude a cut into a part Inventor views the mirrored portion as an unclosed
profile. Is there a way to force the mirrored portion to become a closed
profile without removing the mirror constraint? And yes the part is semetric
in all axis.