Inventor General Discussion

Inventor General Discussion

Reply
Mentor
tmccar
Posts: 478
Registered: ‎11-28-2007
Message 1 of 5 (208 Views)
Accepted Solution

No balloon around numbers

208 Views, 4 Replies
08-15-2012 06:44 AM

I am putting balloons on an assembly drawing, but the circle is not appearing. The arrow, leader and number are there, but  no circle. What could be wrong?

Under the manage tab you have style and Standard editor in that are all the standards.. See Pic.

 

Manage.JPG

*Pro
jletcher
Posts: 1,975
Registered: ‎05-18-2011
Message 2 of 5 (204 Views)

Re: No balloon around numbers

08-15-2012 06:57 AM in reply to: tmccar

Well I don't know you don't explain or tell us anything. What is your style of balloon set to is it set to show a circle? If so then a version of Inventor would be nice so those that had an issue with balloons will know if it is the same issue they had  and can tell you how they fixed it.


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Mentor
tmccar
Posts: 478
Registered: ‎11-28-2007
Message 3 of 5 (193 Views)

Re: No balloon around numbers

08-15-2012 08:41 AM in reply to: jletcher

It's Inventor 2012. Where do I set the balloon style?

*Pro
jletcher
Posts: 1,975
Registered: ‎05-18-2011
Message 4 of 5 (189 Views)

Re: No balloon around numbers

08-15-2012 08:50 AM in reply to: tmccar

Under the manage tab you have style and Standard editor in that are all the standards.. See Pic.

 

Manage.JPG


Please mark this response as "Accept as Solution" if it answers your question.

James Letcher
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
Mentor
tmccar
Posts: 478
Registered: ‎11-28-2007
Message 5 of 5 (161 Views)

Re: No balloon around numbers

08-16-2012 02:13 AM in reply to: jletcher

That's it, thanks

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.