Inventor General Discussion

Inventor General Discussion

Valued Contributor
Posts: 72
Registered: ‎08-16-2010
Message 11 of 13 (163 Views)

Re: New to Inventor 2013

10-11-2012 09:41 AM in reply to: JDMather

We're currently designing the course for SW 2012 and it should be released in a few weeks. Then we will move into 2013.  I haven't had time to explore the pre-release versions of 2013, but from what I have read they have expanded on the Sheet Metal environment.  I'll be interested to see the new changes/ additions.

John Koop
Software Engineer/ Inventor Specialist
TEDCF Publishing
Posts: 21
Registered: ‎12-24-2011
Message 12 of 13 (88 Views)

Re: New to Inventor 2013

03-10-2013 06:09 PM in reply to: JDMather

I am on the hunt for answers about precise input using the offset tool.


I'm evaluating Inventor LT right now after using AutoCAD for 15 years.  Since direct input apparently isn't working, what is the best way to precisely use the offset tool?


Thanks for having a look!

*Expert Elite*
Posts: 28,227
Registered: ‎04-20-2006
Message 13 of 13 (82 Views)

Re: New to Inventor 2013

03-10-2013 06:42 PM in reply to: CuriousYellow

In Inventor geometry is driven by (controlled by) dimensions.

Add dimension.

In AutoCAD dimensions are drivenbt geometry (unless using Parametric tab in later releases).

Please mark this response as "Accept as Solution" if it answers your question.
Autodesk Inventor 2015 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.