Inventor General Discussion

Inventor General Discussion

Reply
Member
pineapplexpressdf
Posts: 4
Registered: ‎02-28-2012
Message 1 of 2 (326 Views)

Need Help With Car Model

326 Views, 1 Replies
01-02-2013 06:58 PM

I'm a high school student with a bit too much time on their hands right before Build season starts for robotics. I decided to make a model car but ran into a problem. I know a great way to surface model is to do surface extrudes and to sculpt them all together into one solid body, as depicted here, http://www.youtube.com/watch?v=vaJE6N3jHXE . While that is relatively simple, I have run into a problem. I am not using the same method as shown in the video, and only have three sketches (front, top, and side). I was wondering if there is any way for me to extrude them all and then cutout whatever doesn't intersect with the other two extrusions? 

 

 

Edited by
Discussion_Admin

*Expert Elite*
JDMather
Posts: 28,056
Registered: ‎04-20-2006
Message 2 of 2 (297 Views)

Re: Need Help With Car Model

01-03-2013 05:10 AM in reply to: pineapplexpressdf

See attached.

 

There are a bunch of surfacing tutorials in my signature.

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!