Inventor General Discussion

Inventor General Discussion

New Member
Posts: 1
Registered: ‎01-22-2013
Message 1 of 2 (139 Views)

Multi Problems with Inventor 2013

139 Views, 1 Replies
01-22-2013 05:43 PM


Recently installed Inventor 2013 before Holiday break (mid December). In assemblies, when importing nuts, bolts, screws, etc, from libraries and after inserting items in place and then save & close program and bring file up  later or next day, these items are missing from the assembly. Error messages appear in the browser. It seems to be doing this on more than one computer.

Valued Mentor
Posts: 313
Registered: ‎05-23-2007
Message 2 of 2 (127 Views)

Re: Multi Problems with Inventor 2013

01-22-2013 08:06 PM in reply to: RodBuck1357



"Multi problems" ?? It's not that bad, you have a file path issue to the content center files.

Did you set up a project?

How did you send the assembly to the other computers?

Was is on a shared drive? If so then map the CC location to a shared folder, this way everyone will have access to all the cc files.


If you copied the files, rather do a Pack n GO, this will ensure that all files have been collected to allow the assembly to open correctly.


What I do to solve the issue is to re-map the default CC location, it makes it easier to syncronise the folders if you don't have Vault.




cc files.JPG

Autodesk PDS Ultimate 2015 Update 1 Build 159
Intel Core i7 (950@3.07GHz)/Win7x64 (Home) - 12GB Ram
Nvidia GeForce GTX 560 Ti
Please Give Kudo's / accept as a solution if it fixes your problem.
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.