Community
Inventor Forum
Welcome to Autodesk’s Inventor Forums. Share your knowledge, ask questions, and explore popular Inventor topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Move part along curve with chaindrive in assembly

3 REPLIES 3
Reply
Message 1 of 4
sjowe
399 Views, 3 Replies

Move part along curve with chaindrive in assembly

Hi!

 

New on this forum, and hope to get some tips how to solve my problem.

 

I have two set of chaindrives connected to eachother through a common axle.

The motor (which is not visible in my assembly) drives the yellow sprocket. 

The two sprockets mounted on the grey axle is attached with a keyway so when the yellow sprocket turns, the two chaindrives turns.

 

I want to attach the blue sled on the blue chain, the red sled on the red chain and then rotate the yellow sprocket so both of the sleds moves with their chains (at the same speed/ time).

 

The blue sled is going to move a rolled bar (the orange one) on the floor (glass square) a certain length and then the red sled is going to "take over" and continue to move the bar on the floor.

 

I want to make sure I´ve got the spacing between the sprockets in the short chaindrive (red) correct so the red sled takes over when the blue sled disapperes under the floor.

 

Best regards

 

Jonathan

 

http://imgur.com/a4d46

 

http://imgur.com/AQbFf

 

http://imgur.com/j53Qo

 

http://imgur.com/RSMrx

 

Edit: I use IV 2012, but I also downloaded IV 2013 professional (trial) so I can use the dynamic motion.

3 REPLIES 3
Message 2 of 4
JDMather
in reply to: sjowe

Wasim Younis http://www.amazon.com

 


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Message 3 of 4
sjowe
in reply to: sjowe

Anyone?

Message 4 of 4
JDMather
in reply to: sjowe

See Wasim Younis book - you can get here http://www.amazon.com

or

ask your instructor

or

attach your assembly here (it isn't easy to describe technique).


-----------------------------------------------------------------------------------------
Autodesk Inventor 2019 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional


The CADWhisperer YouTube Channel


EESignature

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report