Inventor General Discussion

Reply
Contributor
bobbie.k
Posts: 22
Registered: ‎06-15-2012
Message 1 of 1 (104 Views)

Mould base

104 Views, 0 Replies
09-26-2013 02:40 PM

Hi All,

 

Has anyone ever had a problem with inserting a mould base using 2014?

 

Everytime I go to insert a mould base my computer freezes and doesn't respond. This has only occured recently, within the past week as I created a full mould tool just recently. I haven't made any changes to my computer or software so I have no idea why this is happening! If I open a mould tool created before, I can modify it no problem, but if i delete it and try to add in a new one the problem persists!

 

Really thrustrating as I need to get this job completed soon. Anyone have any idea as to what might have happened?

 

thanks for any help given.

 

Regards,

 

Rob

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.