Inventor General Discussion

Reply
*Expert Elite*
JDMather
Posts: 27,478
Registered: ‎04-20-2006
Message 11 of 12 (108 Views)

Re: motion

11-12-2012 08:00 AM in reply to: ijc

Do you have the Wasim Younis book?

 

Is something like this exercise from the book what you are trying to do?

 

 

Please mark this response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------
Autodesk Inventor 2014 Certified Professional
Autodesk AutoCAD 2013 Certified Professional
Certified SolidWorks Professional
Inventor Professional 2015-SP1 64-bit
http://www.autodesk.com/edcommunity
http://home.pct.edu/~jmather/content/DSG322/inventor_surface_tutorials.htm
Distinguished Contributor ijc
Distinguished Contributor
ijc
Posts: 150
Registered: ‎07-03-2010
Message 12 of 12 (89 Views)

Re: motion

11-13-2012 03:45 AM in reply to: JDMather

I have just ordered that book..yes it is similiar to the file you attached The conveyor track attached has the belt (links) travelling along the top and returning along the bottom i one continuos motion....the problem i have is that i wanted to use the point-curve sliding joint so as the links move as real life...can this sketch be created on the same track but not use the 3D sketch so as to use the the point-curve sliding joint

What are your thoughts?

Thank you

IJC

Inventor 2013

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.