Inventor General Discussion

Inventor General Discussion

Reply
New Member
knrdptr
Posts: 2
Registered: ‎11-09-2012
Message 11 of 11 (146 Views)

Re: Mold design and content center

11-12-2012 10:41 AM in reply to: lucmartzz

I tried to run it in administration mode, but running that way mold assembly tab and core&cavity tab is not even active, I cannot create a mold. I tried to reinstall it, but the problem persists. I don't want to format my partition so now I decided to install Inventor 2012, and it works fine. 

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.