My company is trying to Standardize all drawings produced to 1 format. the one we are attempting to create would be in the form of: nominal upper limit^lower limit. this is easily acheived in autocad and linear, chamfer, and hole/thread dimensions in inventor. but radii's and diameters from a round surface (as apposed to linear diameters) we have run into a snag with. We cannot seem to find a way to either remove the prefix symbols or be able to insert text between the symbol and tolerance.
below is a illistration of the problem and the form of the new dimensions.
if anyone knows where i can find these controles, the information would be much appreciated.
My company is trying to Standardize ....
What standard are you using? (Example - ASME/ANSI Y14.41).
we aren't really using a set ANSI standard right now. every engineer has his own method right now.
Perhaps the easiest way to introduce and enforce a common standard is to agree to use a National Standard.
I have been trying for the last 3 years but this is what the management feel is our better option. so back to the original question: Is there a way to remove the diameter and radius symbol from appearing on their own?
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.