Inventor General Discussion

Inventor General Discussion

Reply
*Purge
Message 1 of 3 (94 Views)

Modeling in Inventor, detailing in Mechanical

94 Views, 2 Replies
10-31-2002 05:49 AM
Just curious. Anyone out there using both Inventor and Mechanical 6 to
create your drawings. What I am saying is, using Inventor to create the
models and generate the views and bom. Then exporting that out to Mechanical
6 to be detailed. Yes, I know the views will not update once it is exported.
I feel that Inventor's ability to detail in the idw is still not as strong
or flexable as it is in a 2D package. Especially when dealing with a lot of
circular and cylindrical parts.

So if anyone out there is using both, I would like some of your feedbacks.
Good and bad. Or if you feel that this is not the way to go, please argue
your point. I am open to suggestions. TIA
Distinguished Contributor
MechMan_
Posts: 2,037
Registered: ‎12-12-2003
Message 2 of 3 (94 Views)

Re: Modeling in Inventor, detailing in Mechanical

10-31-2002 06:06 AM in reply to: *Purge
What I dislike most about this approach is that unless you intend to trash the 3D model you'll have to keep up with 2 unassociated data sets. After converting to 2D you need to make it known to your team that the 3D model is no longer an up-to-date and valid design source and in essense that model becomes worthless after a few changes are made. Updating the 2D drawing and 3D model would be a time-consuming and unreliable task. I don't know about you but I always seem to catch a few of my design mistakes during the detailing process and not always during the design modeling process. It's then that the power of parametric modeling and associative drawing views becomes a massive time saver.


MechMan
*Biskupski, Janek
Message 3 of 3 (94 Views)

Re: Modeling in Inventor, detailing in Mechanical

11-03-2002 08:19 PM in reply to: *Purge
Hi!

Same thoughts as MechMan already wrote...

I'm doing this at the very moment, because I work for a team that only has
Mechanical (2000), and no Inventor. So I generate the views in Inv, export
to dwg and detail it in dwg.

I don't like this - I would much prefer to do everything in Inv - mostly for
what Mechman pointed out - associativity. But in fact I never liked
Mechanical more than Inv, so my approach may be different :smileyhappy:

Of course this way (Inv > Mechanical) it is easy to do all kinds of
"cheating" :smileyhappy:

Best Regards,
Janek
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.