Inventor General Discussion

Inventor General Discussion

Reply
Mentor
petestrycharske
Posts: 207
Registered: ‎09-10-2012
Message 1 of 2 (169 Views)

Missing Old Constraint Error Dialogue Box

169 Views, 1 Replies
12-06-2012 07:07 AM

In Inventor 2011 and previous, one could detect assembly constraint errors by taking a component that was not fully constrained and manipulating it via a mouse click and drag.  This would launch a dialogue box listing all the constraints that are having problems and still allow you to accept the manual part manipulation.  However, I am now using Inventor 2013 and when I have constraint errors, I cannot manually manipulate non-fully constrained objects and do not get that overall constraint error dialogue box.  Is there a setting to turn this back on?  Wish I could post a screen shot, but obviously unable to.  Thanks and have a great day!

 

Thanks,

Pete

Mentor
petestrycharske
Posts: 207
Registered: ‎09-10-2012
Message 2 of 2 (165 Views)

Re: Missing Old Constraint Error Dialogue Box

12-06-2012 07:31 AM in reply to: petestrycharske

Was able to scrounge up a dialogue box.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.